A vape label carries four or five numbers, and most buyers can only interpret one of them. That is a problem, because the label is the only place the seller is legally and commercially on the record about what is inside.

Number one: the strength, printed two ways

You will see either a percentage or mg/mL. They describe the same thing:

  • 1% = 10 mg/mL.
  • 2% = 20 mg/mL.
  • 3.5% = 35 mg/mL.
  • 5% = 50 mg/mL.

A 5% disposable and a "50 mg" disposable are identical in strength. A listing that shows 5% but calls it 20 mg/mL is either sloppy or dishonest, and both are reasons to buy elsewhere.

Number two: the volume, in mL

This is the size of the liquid reservoir. Pods typically hold 2 mL, disposables 10 to 18 mL depending on the format. Volume matters because it sets the cost per mL, and because larger reservoirs need higher resistance pods to avoid flooding.

Number three: the puff count

Puff counts are marketing estimates, not measurements. A "5,000 puff" disposable is tested at roughly one second per puff on a machine. Real users take longer draws. Expect 60 to 70% of the printed figure in real use, which means a 5,000 puff device is realistically 3,000 to 3,500 puffs for a human being.

Use puff count only to compare two devices from the same brand. Never use it to compare brands, because the test conditions differ.

Number four: resistance, in ohms

Resistance decides how the device behaves, and it is the number most often left off the pack:

  • Above 1.0 ohm: low power, tight draw, made for high-strength salt. Cigarette-like.
  • 0.6 to 1.0 ohm: middle ground, more vapour, works with 20 to 35 mg/mL salt.
  • Below 0.6 ohm: sub-ohm, high power, large vapour, needs 3 to 6 mg/mL freebase.

If the resistance is not printed anywhere, the product is aimed at people who will not notice — and that is usually a sign of a low-information SKU.

Number five: the batch and the expiry

Liquid has a shelf life, usually about two years from manufacture, printed as a batch code plus a date. Nicotine degrades and the liquid darkens. A pack without any batch code cannot be traced, which matters if the product is defective.

What the label deliberately leaves out

Three things you will rarely find, and should:

  1. The manufacturer, as a legal entity — not just a flavour brand name.
  2. An ingredients list. VG/PG ratio, flavourings, and whether the nicotine is salt or freebase.
  3. Device compatibility. Which pods, which wattage, which charging standard.

None of these are legally required on every pack in every state, but a retailer that publishes them on the product page is telling you something about how it sources stock.

The ten-second label check

Before you pay, confirm: strength in both formats, volume in mL, resistance in ohms, and whether the nicotine is salt or freebase. If any of those is missing, you are buying blind.

SmokVera publishes strength, resistance and nicotine type together on each listing, which is the same information the pack should carry.

Read full specs on SmokVera listings

Bottom line

Percent and mg/mL are the same number in different clothes. Puff counts are estimates. Resistance is the spec that actually predicts how the device will feel. Learn those three and the rest of the label stops being decoration.

Once the numbers make sense, the next question is which strength to buy: see Nicotine Strength Explained.

For adults 21+. Nicotine is an addictive chemical. Vaping is not an FDA-approved smoking cessation product.